Power windows with automatic raising/lowering, function - GF72.29-P-3007T

MODEL 211.0 /2 /6 

Function prerequisites 

• No overvoltage or undervoltage
• Circuit 15 ON or circuit 15R ON.
• Power window in normalized state (for automatic raising).
• Function disabled (version coding).
• Power window motor rotation direction correct
• No Hall sensors defective.

Function 

The automatic raising/lowering function is performed by briefly pulling back or pushing forward a power window switch in the "close" or "open" direction beyond the first click-stop position. The corresponding door control module reads in the switch status and then actuates the corresponding power window motor until the position recognition indicates that the window is completely closed or open.

Automatic raising 

The "automatic raising" function effects automatic window raising with excess force limitation (obstruction sensor) and can only be performed on normalized windows. If no other switch position is detected, the window is fully closed as far as the upper block position.

If an incorrect rotation direction of the power window motor or a defective Hall sensor is recognized, the automatic raising function is interrupted immediately.

If an error (incorrect rotation direction, defective Hall sensor) is recognized or when the windows are denormalized, the system will respond to any continued request for "automatic raising" by actuating the "manual raising" function.

If the "manual raising" function is detected after recognition of the "automatic raising" function without previously detecting the nonactuated state, then the "automatic raising" function remains active.

Function abort 

The "automatic raising" function is aborted if:

• Function requirements are not satisfied
• An obstruction is detected
• Another switch position after neutral position is detected
• Response from excessive force limitation (obstruction sensor)
• Activation time exceeded t>25 s
• Zero point tolerance exceeded

Automatic lowering 

The "automatic lowering" button function effects automatic window lowering and can be performed without normalization.

As long as no other switches are recognized, the window is completely opened down to the lower end stop position

Function abort 

The "automatic lowering" function is aborted if:

• Function requirements are not satisfied
• Another switch position after neutral position is detected
• An obstruction is detected
• Activation time exceeded t>25 s
• The maximum travel distance for normalized windows is exceeded

	manual raising/lowering of power windows function		GF72.29-P-3006T
	Power window position recognition, function		GF72.29-P-4000T
	Normalization of power windows, function		GF72.29-P-4003T
	Power window obstruction sensor, function		GF72.29-P-4004T
	Front power window motor, location/function		GF72.29-P-4108T
	Rear power window motor, location/function		GF72.29-P-4109T
	Left front door control module, location/task		GF72.29-P-4115T
	Right front door control module, location/task		GF72.29-P-4116T
	Rear door control module, location/task/ function		GF72.29-P-4117T