Function of gear shift - GF27.60-P-2000GA

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2007 Mercedes-Benz C350, 2007 Mercedes-Benz C280, 2007 Mercedes-Benz C230, 2006 Mercedes-Benz C55, and 2006 Mercedes-Benz C350. However, it is still accessible from the selected car via links, so may be relevant.

TRANSMISSION 722.6 in MODEL 163, 170, 202, 208, 210 with touch shift

TRANSMISSION 722.6

in MODEL 203 up to 23.4.04,

215, 220, 240 (except 215.374 /379, 220.074 /174 /179)

On transmission 722.6 the electrohydraulic control unit converts the electric signals going out from the electronic transmission control (EGS) into hydraulic signals.

Faults occurring in the ETC control unit (N15/3) are handled by the limp-home system. The limp-home system is designed so that the driver can reach a Service Operation even under extreme conditions.

Selector lever positions "P", "R", "N" and "D" are transmitted by the electronic selector lever module control unit (N15/5) on the Controller Area Network bus class C (engine compartment) (CAN-C) and in parallel to this by means of a shift rod to the range selector lever at the transmission end. By touching or holding the selector lever towards "+" or "-" the shift range is preselected and displayed in the instrument cluster (A1) until an upshift of transmission 722.6 is possible.

Function of gear change		GF27.60-P-3010G
Emergency default mode, function		GF27.60-P-3012G
Function of manual drive mode selection	Model 163	GF27.60-P-3011GI
	Model 170, 202, 208, 210	GF27.60-P-3011GB
	Model 203 up to 31.05.03	GF27.60-P-3011P
	Model 203 as of 01.06.03	GF27.60-P-3011PZ
	Model 215, 220 up to 31.08.02	GF27.60-P-3011GA
	Models 215, 220 as of 01.09.02, 240	GF27.60-P-3011GAZ
Oil level control, function		GF27.10-P-3024G
Torque converter lockup clutch control, function		GF27.20-P-3002G