TELE AID control module, function - GF82.95-P-4100-04A

In the emergency call system control module (TELE AID, A35/8)  all data important for a TELE AID emergency call are processed centrally (with code 930 also data of taxi emergency call). It calculates the vehicle position with the aid of the installed GPS control module and generates an emergency call telegram in the event of an emergency call. An installed roll-over sensor recognizes when the vehicle rolls over.

The data from the emergency tensioning retractor control module with airbag (AB, N2/2) (not models 215, 220)  are received via serial interface. On models 215, 220 the emergency tensioning retractor control module with airbag (AB, N2/2)  is replaced by the restraint system control module (N2/7)  .

The CTEL transmitter and receiver (A35)  and the CTEL handset (A34)  are connected directly to the emergency call system control module (TELE AID, A35/8)  . Both units can be actuated by the emergency call system control module (TELE AID, A35/8)  directly via the serial TELE AID interface (DSC uplink, DSC downlink).

The emergency call system control module (TELE AID, A35/8)  is capable of HHT diagnosis

The emergency call system control module (TELE AID, A35/8)  should not be turned around the longitudinal or lateral axis when circuit 15R is "ON". The installed rollover sensor would in this case recognize a rollover and trigger a TELE AID emergency call. For this purpose always lay the emergency call system control module (TELE AID, A35/8)  down in installation position when removed and when leads are connected and secure against falling down.