Retrieving Codes

Using Adapter Harness (965 589 00 40 00), connect Hand-Held Tester (965 589 00 01 00) to data link connector. Retrieve and record codes from combination control module using manufacturers instructions. Perform appropriate system test. See DTC IDENTIFICATION CHART table.

DTC IDENTIFICATION CHART

Code

Possible Cause

Test Step

B1000

Combination Control Module (CCM)

Replace CCM

B1001

Elect. Seat Adjustment (ESA) Control Module

Replace ESA Control Module

B1010

Low Voltage

⁽¹⁾

B1011

Excess Voltage

⁽¹⁾

B1013

Circuit 15R

⁽²⁾

B1015

Circuit 30C, Fuse No. 7

⁽²⁾

B1017

Circuit 31B

⁽²⁾

B1022

No Communication Through CAN Data Line

⁽³⁾

B1024

CAN Low-Interior Bus Circuit Open Or Short

⁽⁴⁾

B1025

CAN High-Interior Bus Circuit Open Or Short

⁽⁵⁾

B1114

St. Column Adjustment Switch Ckt Short To Ground

⁽⁶⁾

B1119

Outside Mirror Adjust Switch Open Or Short ckt

⁽⁷⁾

B1213

Driver's Outside Mirror Open Circuit

⁽⁷⁾

B1214

Driver's Outside Mirror Motor Circuit Short

⁽⁶⁾

B1408

Steering Column Motor Circuit Short

⁽⁸⁾

B1409

Steering Column Motor Circuit Short

⁽⁹⁾

B1410

Combination Control Module Does Not Switch

Replace CCM

⁽¹⁾	Check charging system and repair as necessary.

⁽²⁾	Perform TEST 2 under SYSTEM TESTS.

⁽³⁾	Perform pneumatic system equipment test steps 21) through 25). See PNEUMATIC SYSTEM EQUIPMENT (PSE) under SYSTEM TESTS in DOOR LOCKS - PNEUMATIC & POWER article.

⁽⁴⁾	Perform pneumatic system equipment test steps 21), 24) and 25). See PNEUMATIC SYSTEM EQUIPMENT (PSE) under SYSTEM TESTS in DOOR LOCKS - PNEUMATIC & POWER article.

⁽⁵⁾	Perform pneumatic system equipment test steps 21), 23) and 25). See PNEUMATIC SYSTEM EQUIPMENT (PSE) under SYSTEM TESTS in DOOR LOCKS - PNEUMATIC & POWER article.

⁽⁶⁾	Perform TEST 7 through TEST 9 under SYSTEM TESTS.

⁽⁷⁾	Perform TEST 1 , TEST 3 and TEST 4 under SYSTEM TESTS.

⁽⁸⁾	Perform TEST 5 through TEST 8 under SYSTEM TESTS.

⁽⁹⁾	Perform TEST 10 through TEST 13 under SYSTEM TESTS.