Fault Code Identification
NOTE:
System is tested as an integrated unit. To perform tests on specific circuits and/or components, Contact Box (140 589 06 63 00), Contact Module (140 589 04 63 00), 126-pin Socket Box (129 589 00 21 00) and digital volt/ohmmeter are required.
NOTE:
Specific testing of circuits and/or components is not available.
ABS CONTROL UNIT FAULT CODE IDENTIFICATION
| Fault Code | Malfunctioning Component/System | ||
|---|---|---|---|
| 1 | (1) | ||
| 2 | Left Front Wheel Speed Sensor | ||
| 3 | Right Front Wheel Speed Sensor | ||
| 4 | Rear Axle Speed Sensor | ||
| 6 | Left Front Axle Solenoid Valve | ||
| 7 | Right Front Axle Solenoid Valve | ||
| 8 | Rear Axle Solenoid Valve | ||
| 10 | Return/Pressure Pump Motor Or Return/Pressure Pump Relay | ||
| 11 | Solenoid Valve Relay | ||
| 12 | Master Cylinder Switchover Valve | ||
| 13 | Stoplight Switch | ||
| 14 | ABS/ASR Lateral Acceleration Sensor | ||
| 15 | ABS Control Unit | ||
| 16 | Speed Sensors Wrong Or Dirty/Damaged Tooth Rotor | ||
| 17 | Low Voltage At Solenoid Valve Relay | ||
|
|||
BASE MODULE FAULT CODE IDENTIFICATION
| Fault Code | Malfunctioning Component/System | ||
|---|---|---|---|
| 1 | (1) | ||
| 5 | Maximum Permissible Temperature In Module Box Exceeded | ||
| 6 | A/C Compressor Electromagnetic Clutch Blocked | ||
| 7 | Poly-V-Belt Slipping | ||
| 9 | Voltage Supply For LH-SFI Control Unit Interrupted | ||
| 10 | Voltage Supply For LH-SFI Control Unit Interrupted Or Voltage Supply For Fuel Injectors Interrupted | ||
| 11 | Voltage Supply For Accessory Equipment Control Units Interrupted | ||
| 12 | Voltage Supply For ABS Control Unit Or ABS/ASR Control Unit Interrupted | ||
| 15 | Voltage Supply For Automatic Transmission Kickdown Valve Interrupted | ||
| 16 | Voltage Supply For A/C Compressor Electromagnetic Clutch Interrupted | ||
| 17 | Voltage Supply For Module Box Blower Motor Interrupted | ||
|
|||