DTC Inspection: Notes

Quick Check 

1. Connect the M-MDS to the DLC-2.
2. Switch the ignition ON (engine off or on).
3. Perform the vehicle identification.
4. Select the [Quick Check] from the initialization screen of the M-MDS.
5. Verify DTCs following the instructions on the screen.
   • If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection after recording the freeze frame data/snapshot data.
     NOTE:

     • Each module condition can be determined by the color of the displayed module.

     -Green: No DTCs 

     -Red: Communication Error 

     -Blue: No Communication or Not Equipped 

     -Orange: DTC(s) exist 

     -Gray: DTC Not Supported 

   • If a module displayed in orange (DTC(s) exist) is selected, the DTCs stored in the selected module are displayed in a list. 
   • If the following icon is selected, the DTCs stored in all the modules are displayed in a list. 

     Courtesy of MAZDA MOTORS CORP.

   • If the following icon is selected on the DTC list screen, the freeze frame data/snapshot data relative to the applicable DTC is displayed. 

   Courtesy of MAZDA MOTORS CORP.