Remove Rear Propeller Shaft: Notes

Remove using the procedure shown in the figure.

Step 1

Fig 1: Rear Propeller Shaft Components Location With Torque Specifications (Step 1)

Courtesy of MAZDA MOTORS CORP.

TIGHTENING TORQUE SPECIFICATIONS

Procedure	Part name
1	Connector	-	-
2	Bolt	-	9.5 N.m {95 kgf.cm, 82 in.lbf}
3	O-ring	Replacement part	-
4	Bolt	-	9.5 N.m {95 kgf.cm, 82 in.lbf}
5	Nut	-	9.5 N.m {95 kgf.cm, 82 in.lbf}
6	Bolt	-	9.5 N.m {95 kgf.cm, 82 in.lbf}
7	O-ring	Replacement part	-
8	High voltage battery coolant cooling piping component	-	-

Step 2

Fig 2: Rear Propeller Shaft Components Location With Torque Specifications (Step 2)

Courtesy of MAZDA MOTORS CORP.

TIGHTENING TORQUE SPECIFICATIONS

Procedure	Part name
9	Heater hose (See Heater hose connection note )	_	-
10	Heater hose (See Heater hose installation note )	-	-
11	Heater hose (See Heater hose connection note )	-	-
12	Heater hose (See Heater hose connection note )	-	-
13	Bolt	-	11 N.m {110 kgf.cm, 95 in.lbf}
14	Heater pipe component (See HEATER PIPE COMPONENT INSTALLATION NOTE )	-	-
15	Bolt	-	80 N.m {8.15 kgf.m, 59 ft.lbf}
16	Nut	-	-
17	Bolt	-	44.5 N.m {4.55 kgf.m, 32.95 ft.lbf)
18	Rear propeller shaft (See Rear propeller shaft removal note (reused) ). (See Rear propeller shaft installation note (reused) ). (See Rear propeller shaft installation note (newly replaced) ).	-	-