Diagnostic Procedure

POSITION CANNOT BE PROGRAMMED (POSITION MEMORY SYSTEM) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	VERIFY ALL SYSTEM DTCs Perform the quick check. (See DTC INSPECTION .) Are any DTCs displayed?	Yes	Repair or replace the malfunctioning location according to the applicable DTC troubleshooting.
1		No	Go to the next step.
2	INSPECT POSITION MEMORY SWITCH FOR MALFUNCTION Inspect the applicable part. (Refer to [POSITION MEMORY SWITCH INSPECTION ] in Service Information). Is the part normal?	Yes	Go to the next step.
2		No	Repair or replace the malfunctioning location and perform the repair completion verification 1. (Refer to [POSITION MEMORY SWITCH REMOVAL/INSTALLATION ] in Service Information).
3	INSPECT INSTRUMENT CLUSTER FOR MALFUNCTION Inspect the applicable part. (Refer to [INSTRUMENT CLUSTER INSPECTION ] in Service Information). Is the part normal?	Yes	Go to the next step.
3		No	Repair or replace the malfunctioning location and perform the repair completion verification 1. (Refer to [INSTRUMENT CLUSTER REMOVAL/INSTALLATION ] in Service Information).
4	INSPECT NOTIFICATION AND WARNING SPEAKER FOR MALFUNCTION Inspect the applicable part. (Refer to [NOTIFICATION AND WARNING SPEAKER INSPECTION ] in Service Information). Is the part normal?	Yes	Go to the next step.
4		No	Repair or replace the malfunctioning location and perform the repair completion verification 1. (Refer to [NOTIFICATION AND WARNING SPEAKER (FRONT) REMOVAL/INSTALLATION ] in Service Information). (Refer to [NOTIFICATION AND WARNING SPEAKER (REAR) REMOVAL/INSTALLATION ] in Service Information).
Repair completion verification 1	VERIFY THAT VEHICLE IS REPAIRED Install/connect the part removed/disconnected during the troubleshooting procedure. Has the malfunction symptom been eliminated?	Yes	Complete the symptom troubleshooting. (Explain contents of repair to customer)
Repair completion verification 1		No	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See MALFUNCTION DIAGNOSIS FLOW [CONTROLLER AREA NETWORK (CAN)] .) If the CAN communication is normal, perform the diagnosis from Step 1. If the malfunction is not resolved, replace the position memory control module. (Refer to [POSITION MEMORY CONTROL MODULE REMOVAL/INSTALLATION ] in Service Information).