DTC U0320-82: Error Signal Received From Electric Power Steering (EPS) Control Module
U0320:82 (BCM) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location | Error signal received from EPS control module | |
|---|---|---|
| Detection condition |
|
|
| Fail-safe |
|
|
| Vehicle status when DTCs are output | Not applicable | |
| Repeatability verification procedure | 1. Clear the DTC recorded in the memory. (See CLEARING DTC .) | |
| Inspection/action procedure | This DTC may be displayed due to the following DTC. If the following DTC is displayed, give priority to performing the inspection/action. EPS control module (See DTC TABLE [EPS] .) Proceed with the inspection/treatment in the order from Step 1 below. After part repair or replacement, perform the repeatability verification procedure and perform a DTC inspection. (See DTC INSPECTION .) - If the DTC inspection indicates the same DTC again, go to the next step. 1. Replace the steering gear and linkage. |
|
| Purpose/reason (possible cause) | EPS control module malfunction (applicable part cannot be inspected to determine integrity) | |
| Referred to service information item | STEERING GEAR AND LINKAGE REMOVAL/INSTALLATION | |
| 2. Replace the body control module (BCM). | ||
| Purpose/reason (possible cause) | Body control module (BCM) malfunction (no other possible malfunction considered) | |
| Referred to service information item | BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION | |
| System wiring diagram |
|
|
| Function explanation (DTC detection outline) | • Not applicable | |