Function Inspection
WARNING: This page is about a different car, the 2025 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PID BBP. (See ON-BOARD DIAGNOSTIC TEST [PCM (VIN M)] .) (See PCM INSPECTION (VIN M) .)
- Compare the voltage and power brake unit vacuum indications for the PID BBP with the standard in the table indicated below.
- If they do not match the standard, replace the PCM. (See PCM REMOVAL/INSTALLATION (VIN M) .)
- If they match the standard, perform the voltage inspection. (See Voltage Inspection .)
STANDARD SPECIFICATION
| BBP | |
|---|---|
| V | kPa {kgf/cm2 , psi} |
| Approx. 0.29 | 7.54 {0.0769, 1.09} |
| Approx. 3.81 | 96.7 {0.986, 14.0} |