LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-50 S Preferred >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Lighting System) >> High-Mount Brake Light Removal/Installation

High-Mount Brake Light Removal/Installation

WARNING: This page is about a different car, the 2024 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts.
    1. Liftgate upper trim (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION .)
    2. Rear spoiler (See REAR SPOILER REMOVAL/INSTALLATION .)
    3. Side spoiler (See SIDE SPOILER REMOVAL/INSTALLATION .)
  3. Remove the screws.
    G13115167Courtesy of MAZDA MOTORS CORP.
  4. While pressing the rear spoiler tab in the direction of arrow (1) shown in the figure above, pull the cover in the direction of arrow (2) shown in the figure above, and detach the rear spoiler tab from the cover.
  5. Remove the clip.
  6. Remove the cover.
  7. Remove the screws.
    G13115168Courtesy of MAZDA MOTORS CORP.
  8. Remove the high-mount brake light.
  9. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals