DTC U0415-68: Error Signal Received From Electronically Controlled Brake Unit/DSC HU/Cm
U0415-68: (VCM) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Error signal received from electronically controlled brake unit/DSC HU/CM |
| Detection condition |
- When any of the following conditions is met.
- The vehicle control module (VCM) receives the error signal from the electronically controlled brake unit/DSC HU/CM.
- The vehicle control module (VCM) detects that the brake signals between electronically controlled brake unit/DSC HU/CM and the following modules did not match during brake pedal operation while the vehicle is being driven.
- ECM (e-SKYACTIV PHEV)/PCM (except e-SKYACTIV PHEV)
- Front radar sensor
- Body control module (BCM)
- The vehicle control module (VCM) detects that a fail-safe is operated based on a deceleration request while the vehicle is being driven.
|
| Fail-safe |
(See DTC TABLE [VCM] .) |
| Possible cause |
- Internal malfunction related DTCs are stored in the following modules.
- DTCs are stored in the following modules.
- ECM (e-SKYACTIV PHEV)/PCM (except e-SKYACTIV PHEV) malfunction (Refer to PCM REMOVAL/INSTALLATION [SKYACTIV-G (WITH CYLINDER DEACTIVATION)]
, or PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.5T]
in service information.)
- Electronically controlled brake unit/DSC HU/CM malfunction (Refer to [ELECTRONICALLY CONTROLLED BRAKE UNIT REMOVAL/INSTALLATION]
in service information.) (Refer to DSC HU/CM REMOVAL/INSTALLATION
in service information.)
- Vehicle control module (VCM) malfunction (built into body control module (BCM)) (Refer to BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION
in service information.)
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See
CLEARING DTC
.)
- Operate the brake pedal while the vehicle is being driven.
|
| System wiring diagram |
|