Diagnostic Procedure

HDMI IMAGE NOT OUTPUT DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	VERIFY ALL SYSTEM DTCs Perform the DTC inspection. (Refer to the DTC INSPECTION in the service information) Are any DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting.
1		No	Go to the next step.
2	INSPECT USB PORT/SD CARD SLOT HUB FOR MALFUNCTION Inspect the applicable part. (Refer to the USB PORT/SD CARD SLOT HUB INSPECTION in the service information) Is the part normal?	Yes	Go to the next step.
2		No	Repair or replace the malfunctioning location and perform the repair completion verification. (Refer to the USB PORT/SD CARD SLOT HUB REMOVAL/INSTALLATION in the service information)
Repair completion verification	VERIFY THAT VEHICLE IS REPAIRED Install/connect the part removed/disconnected during the troubleshooting procedure. Has the malfunction symptom been eliminated?	Yes	Complete the symptom troubleshooting. (Explain contents of repair to customer)
Repair completion verification		No	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (Refer to the MALFUNCTION DIAGNOSIS FLOW in the service information) If the CAN communication is normal, perform the diagnosis from Step 1. If the malfunction is not resolved, replace the connectivity master unit (CMU). (Refer to the CONNECTIVITY MASTER UNIT (CMU) REMOVAL/INSTALLATION in the service information)