LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2023 >> CX-5 S Select >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Air Bag System (Service Information) - Two-Step Deployment Control System) >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Procedures [Two-Step Deployment Control System] >> Deployment Procedure for Inside of Vehicle >> Pre-tensioner Seat Belt

Pre-tensioner Seat Belt

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the following parts:
    1. Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    3. B-pillar lower trim (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION .)
  2. Remove the pre-tensioner seat belt and connect the SST (Adapter harness)  as shown in the figure. (See FRONT SEAT BELT REMOVAL/INSTALLATION .)
    Fig 1: Connecting SST (Adapter Harness) To Pre-Tensioner
    G10937943Courtesy of MAZDA MOTORS CORP.
  3. Install the pre-tensioner seat belt.
  4. Connect the SST (Deployment tool)  to the SST (Adapter harness)  .
    Fig 2: Connecting SST (Deployment Tool) To SST (Adapter Harness)
    G10937944Courtesy of MAZDA MOTORS CORP.
  5. Connect the SST (Deployment tool)  to the battery. Connect the power supply red clip to the positive battery terminal, and the black clip to the negative battery terminal.
  6. Verify that the red lamp on the SST (Deployment tool)  is illuminated.
  7. Verify that all persons are standing at least 6 m {20 ft}  away from the vehicle.
  8. Press the activation switch on the SST (Deployment tool)  to operate (deploy) the pre-tensioner seat belt.
    Fig 3: Pressing Activation Switch On SST (Deployment Tool)
    G10937945Courtesy of MAZDA MOTORS CORP.
    WARNING:
    • The pre-tensioner seat belt is very hot immediately after it is operated (deployed). You can be burned. Do not touch the pre-tensioner seat belt for at least 15 min after deployment.
  9. Disconnect the SST (Deployment tool)  from the SST (Adapter harness)  .
scientia non olet · About LEMON Manuals