Lumbar Support Motor Inspection
WARNING:
- Handling a side air bag improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings/cautions in the Service Information before handling the front seat (side air bag integrated). (See AIR BAG SYSTEM SERVICE WARNINGS [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.] .) (See AIR BAG SYSTEM SERVICE CAUTIONS [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.] .)
- Switch the ignition OFF (LOCK).
- Disconnect the negative battery terminal and wait for 1 min or more.
(See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)] .)
- Slide hooks A in the order of arrows (1), (2), (3) shown in the figure and disconnect them from hooks B.
- Open fasteners.
- Disconnect the lumber support motor connector.
- Apply battery positive voltage and connect the ground to the lumbar support motor terminals as indicated in the table below and verify the front seat operation condition.
- If the operation cannot be verified as indicated in the table, replace the front seat. (See FRONT SEAT REMOVAL/INSTALLATION [(US)] .)