DTC U2300-55: Configuration Data [DSC HU/Control Module]: Outline
DTC U2300:55 (DSC HU/Control Module) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Configuration data |
| Detection condition |
- The DSC HU/Control Module detects any of the following conditions.
- Configuration procedure not completed
- Signal in which configuration was not implemented is received from body control module (BCM) and PCM
|
| Fail-safe |
Refer to "DTC Table" and "Fail-safe Function Malfunction Contents Table". (See DTC TABLE [DSC HU/Control Module (US)] .) |
| Possible cause |
NOTE:
- To correctly write the configuration data sent from the body control module (BCM) and PCM to DSC HU/Control Module, 30 s or more have to be elapsed since the ignition is switched ON (engine off or on).
- DTCs are stored in the body control module (BCM).
- Body control module (BCM) configuration not implemented
- Body control module (BCM) internal memory malfunction
- Configuration procedure was not completed properly.
- PCM malfunction
- Body control module (BCM) malfunction
- DSC HU/Control Module malfunction
|
| System wiring diagram |
Not applicable |
| Connector diagram |
Not applicable |