Clutch Unit Removal/Installation: Notes

1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
2. Remove the transmission. (See TRANSMISSION REMOVAL/INSTALLATION [M66M-D] .)
3. Remove in the order indicated in the table. 4. Install in the reverse order of removal.
   Fig 1: Clutch Unit Components With Torque Specification

   Courtesy of MAZDA MOTORS CORP.
   PART DESCRIPTION
   
   

   Component no.	Refer to
   1	Boot
   2	Clutch release fork
   3	Clutch release collar
   4	Pivot pin
   5	Clutch cover (See CLUTCH COVER AND CLUTCH DISC REMOVAL NOTE .) (See CLUTCH DISC AND CLUTCH COVER INSTALLATION NOTE .)
   6	Clutch disc (See CLUTCH COVER AND CLUTCH DISC REMOVAL NOTE .) (See CLUTCH DISC AND CLUTCH COVER INSTALLATION NOTE .)
   7	Pilot bearing (See PILOT BEARING REMOVAL NOTE .) (See PILOT BEARING INSTALLATION NOTE .)
   8	Dual-mass flywheel (See DUAL-MASS FLYWHEEL REMOVAL NOTE .) (See DUAL-MASS FLYWHEEL INSTALLATION NOTE .)