Diagnostic procedure

DTC P1886:00 (AWD CONTROL MODULE) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	VERIFY PCM DTC Using the M-MDS, perform the PCM DTC inspection. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)] .) Are any DTCs present?	Yes	Go to applicable DTC inspection. (See DTC TABLE [PCM (SKYACTIV-G 2.5T)] .) DTC troubleshooting completed, then go to the next step.
1		No	Go to the next step.
2	INSPECT THE AWD CONTROL MODULE Is correct AWD control module installed? (See AWD CONTROL MODULE REMOVAL/INSTALLATION .)	Yes	Replace the AWD control module, then go to the next step. (See AWD CONTROL MODULE REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	COUPLING COMPONENT CALIBRATION DATA WRITING Write the coupling component calibration data. (See COUPLING COMPONENT CALIBRATION DATA WRITING .)	-	Go to the next step.
4	VERIFY DTC TROUBLESHOOTING COMPLETED Using the M-MDS, clear the DTC from the AWD control module. (See CLEARING DTC .) Using the M-MDS, perform the AWD control module DTC inspection. (See DTC INSPECTION .) Is the same Pending DTC present?	Yes	Repeat the inspection from Step1. If the malfunction recurs, replace the AWD control module. (See AWD CONTROL MODULE REMOVAL/INSTALLATION .)
4		No	Go to the next step.
5	VERIFY NO DTC IS PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE .)
5	VERIFY NO DTC IS PRESENT Are any DTCs present?	No	DTC troubleshooting completed.