LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 S Select >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Automatic Transaxle Shift Mechanism >> Not P Position Switch Inspection

Not P Position Switch Inspection

NOTE:
  • The not P position switch is built into the selector lever component.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ).
  2. Remove the following parts:
    1. Selector lever knob (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION ).
    2. Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION ).
    3. Switch panel (See SWITCH PANEL REMOVAL/INSTALLATION ).
    4. Cup holder (See CUP HOLDER REMOVAL/INSTALLATION ).
    5. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION ).
    6. Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION ).
    7. Side wall (See SIDE WALL REMOVAL/INSTALLATION ).
    8. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION ).
  3. Disconnect the selector lever component connector.
    G11429134Courtesy of MAZDA MOTORS CORP.
  4. Verify that the continuity between selector lever component terminals B and G.
G11279402Courtesy of MAZDA MOTORS CORP.
NOT P POSITION SWITCH SPECIFICATION

Test condition Continuity
Selector lever is in the P position. No continuity
Selector lever is not in the P position. Continuity
scientia non olet · About LEMON Manuals