Spacer, Rubber and EPS Control Module Installation Note

1. Install the spacer and rubber to the steering column.
2. Install the EPS Control Module so that the projecting part of the EPS Control Module (rotor) is engaged with the notch in the rubber.

Courtesy of MAZDA MOTORS CORP.

CAUTION:

• When assembling the EPS Control Module, be careful not to pinch the torque sensor harness. If the torque sensor harness is damaged, replace the steering column.

NOTE:

• If the projecting part of the EPS Control Module (rotor) is not engaged with the notch in the rubber, adjust the position of the EPS Control Module projection (rotor).