With 360° View Monitor Control Module: Outline
WARNING: This page is about a different car, the 2021 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
DTC U2035:57 [VEHICLE CONTROL MODULE] DETECTION CONDITION AND POSSIBLE CAUSE - WITH 360° VIEW MONITOR CONTROL MODULE
| System malfunction location |
360° view monitor control module calibration data is invalid |
| Detection condition |
- The vehicle control module (VCM) detects that the 360° view monitor control module received invalid calibration data from the vehicle control module (VCM) for 10 s.
|
| Fail-safe |
(See DTC TABLE [VEHICLE CONTROL MODULE (US)] .) |
| Possible cause |
NOTE:
- Depending on the module, after the ignition is switched ON (engine off or on) or OFF, there is a module that needs 30 s to correctly write the calibration data and configuration data.
- Calibration error
- The vehicle control module (VCM) or body control module (BCM) stores DTCs.
- Vehicle control module (VCM) or body control module (BCM) communication error or internal malfunction
- DTCs are stored in the 360° view monitor control module.
- CAN circuit communication error between vehicle control module (VCM) and 360° view monitor control module
- 360° view monitor control module malfunction
- Vehicle control module (VCM) malfunction (built into body control module (BCM))
|
| System wiring diagram |
Not applicable |
| Connector diagram |
Not applicable |