Wheel Unit Id Registration

WARNING: This page is about a different car, the 2021 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

After the wheel unit replacement, registration of the wheel unit identification codes must be performed.
After the LF control unit replacement, registration of the wheel unit identification codes must be performed.

Switch the ignition ON (engine off or on).
Switch the ignition off.
Leave the vehicle with the ignition switched off for 19 min or more.
Switch the ignition ON (engine on).
Drive the vehicle at a speed of 25 km/h {16 mph} or more for 3 min or more.
After driving for 3 min, verify that the TPMS warning light does not flash and is not illuminated.