LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> 3 Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> On-Board Diagnostic - Engine Control (VIN 7/VIN L) (10 Of 10) >> DTC U0452-00: Communication Error With SAS Control Module Error Signal Received From SAS Control Module >> Diagnostic Procedure

Diagnostic Procedure

DTC U0452:00 (PCM, SKYACTIV-G, WITH MAZDA M HYBRID) DIAGNOSTIC PROCEDURE

Step Inspection Results Action
1 RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION 
  • Record the freeze frame data/snapshot data.
    NOTE:
    • Recording can be facilitated using the screen capture function of the PC.
 - Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY 
  • Verify related Service Bulletins, on-line repair information, or Service Information availability.
  • Is any related Information available?
 Yes Perform repair or diagnosis according to the available information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY ELECTRONICALLY CONTROLLED BRAKE UNIT DTCs 
  • Perform the DTC inspection for the electronically controlled brake unit. (See DTC INSPECTION .)
  • Are any DTCs displayed?
 Yes Repair the malfunctioning location according to the applicable DTC troubleshooting.
(See DTC TABLE [ELECTRONICALLY CONTROLLED BRAKE UNIT] .)
No Go to the next step.
Repair completion verification 1 VERIFY THAT VEHICLE IS REPAIRED 
  • Install/connect the part removed/disconnected during the troubleshooting procedure.
  • Clear the DTC recorded in the memory. (See CLEARING DTC .)
  • Replicate the vehicle conditions at the time the DTC was detected using the following procedure.
  • Perform the DTC inspection for the PCM. (See DTC INSPECTION .)
  • Is the same Pending DTC present?
 Yes Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error.
(See CONTROLLER AREA NETWORK (CAN) MALFUNCTION DIAGNOSIS FLOW [(US)] .)
If the CAN communication is normal, perform the diagnosis from Step 1.
No Go to the next step.
Repair completion verification 2 VERIFY IF OTHER DTCs DISPLAYED 
  • Perform the DTC inspection. (See DTC INSPECTION .)
  • Are any other DTCs displayed?
 Yes Repair the malfunctioning location according to the applicable DTC troubleshooting.
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals