DTC U0415-68: ERROR SIGNAL RECEIVED FROM DSC HU/Control Module: Outline
DTC U0415:68 (VEHICLE CONTROL MODULE - US) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Error signal received from DSC HU/Control Module |
| Detection condition |
- When any of the following conditions is met.
- The vehicle control module (VCM) receives the following error signals from the DSC HU/Control Module for 10 s.
- Vehicle longitudinal acceleration
- Brake fluid pressure from master cylinder
- Yaw rate (vehicle turning angle speed)
- Rotation speed of each wheel
- The vehicle control module (VCM) detects that the brake signals between DSC HU/Control Module and the following modules did not match for 10 s during brake pedal operation while the vehicle is being driven.
- PCM
- Front radar sensor
- body control module (BCM)
- The vehicle control module (VCM) detects that a fail-safe is operated based on a deceleration request for 30 min while the vehicle is being driven.
|
| Fail-safe |
(See DTC TABLE [VEHICLE CONTROL MODULE (US)] .) |
| Possible cause |
- CAN BUS No. 1 communication line error
- DSC HU/Control Module malfunction
- Brake fluid pressure sensor malfunction (built into DSC HU/Control Module)
- ABS wheel-speed sensor error
- Brake light illumination function malfunction
- PCM malfunction
- Electrical supply unit (ESU) malfunction
- Brake light illumination function malfunction
- Brake light malfunction
- SAS control module malfunction
- Low-G (XY) sensor error
- Yaw rate sensor error
- Front radar sensor malfunction
- Vehicle control module (VCM) malfunction (built into body control module (BCM))
- Body control module (BCM) malfunction
|
| System wiring diagram |
Not applicable |
| Connector diagram |
Not applicable |