LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> MX-5 Miata RF Club, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Glass/Windows/Mirrors) >> Power Window Regulator Removal/Installation

Power Window Regulator Removal/Installation

WARNING: This page is about a different car, the 2016 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the door glass preparation. (See DOOR GLASS REMOVAL/INSTALLATION .)
  2. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  3. Remove the following parts:
    1. Door trim (See DOOR TRIM REMOVAL/INSTALLATION .)
    2. Door module panel (See DOOR MODULE PANEL REMOVAL/INSTALLATION .)
    3. Door glass (See DOOR GLASS REMOVAL/INSTALLATION .)
  4. Disconnect the connector.
    Fig 1: Identifying Power Window Regulator Connector
    G10954116Courtesy of MAZDA MOTORS CORP.
  5. Remove the nuts (1).
    Fig 2: Identifying Power Window Regulator Nuts
    G10954117Courtesy of MAZDA MOTORS CORP.
  6. Remove the nuts (2).
  7. Remove the power window regulator through the door module panel installation hole.
  8. Install in the reverse order of removal.
  9. Perform the power window system initial setting.(See POWER WINDOW SYSTEM INITIALIZATION PROCEDURE .)
scientia non olet · About LEMON Manuals