Door Lock-Link Switch Inspection: LH
- Fully close the door glass.
- Disconnect the negative battery cable. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Remove the following parts:
- Door trim (See DOOR TRIM REMOVAL/INSTALLATION .)
- Door module panel (See DOOR MODULE PANEL REMOVAL/INSTALLATION .)
- Door key cylinder (See DOOR KEY CYLINDER REMOVAL/INSTALLATION .)
- Inner handle (See INNER HANDLE REMOVAL/INSTALLATION .)
- Door latch and lock actuator (See DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION .)
- When the door lock knob cable is pulled or pressed in, verify that the continuity is as indicated in the table.
- If not as indicated in the table, replace the door latch and lock actuator. (See DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION .)