LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> MX-5 Miata Club, Standard Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Dynamic Stability Control (Service Information) >> Rear Abs Wheel-Speed Sensor Removal/Installation

Rear Abs Wheel-Speed Sensor Removal/Installation

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the trunk end trim. (See TRUNK END TRIM REMOVAL/INSTALLATION .)
  3. When working on the left side of the vehicle, remove the trunk covering. (See TRUNK COVERING REMOVAL/INSTALLATION .)
  4. When working on the left side of the vehicle, remove the partition board. (See PARTITION BOARD REMOVAL/INSTALLATION .)
  5. Remove the trunk side trim. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
  6. When working on the left side of the vehicle, remove the fuel-filler pipe protector. (See FUEL-FILLER PIPE REMOVAL/INSTALLATION [SKYACTIV-G 2.0] .)
  7. Disconnect the rear ABS wheel-speed sensor connector.
    G13489062Courtesy of MAZDA MOTORS CORP.
  8. Press out the rear ABS wheel speed sensor toward the outside of the vehicle while pressing the grommet tabs.
    G11273862Courtesy of MAZDA MOTORS CORP.
  9. Remove in the order indicated in the table.
  10. Install in the reverse order of removal.
  11. After installation, verify that there is no twisting in the rear ABS wheel-speed sensor.
    Fig 1: Rear ABS Wheel-Speed Sensor Components With Torque Specification
    G13489064Courtesy of MAZDA MOTORS CORP.
    COMPONENT DESCRIPTION

    1 Harness clip
    2 Grommet
    3 Bolt
    4 Rear ABS wheel-speed sensor
scientia non olet · About LEMON Manuals