LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> MX-5 Miata Club, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Intake Air System >> Intake-Air System Removal/Installation >> Intake Manifold Installation Note

Intake Manifold Installation Note

  1. Install the intake manifold.
  2. Connect the harness clip from the intake manifold as shown in the figure.
    G13488162Courtesy of MAZDA MOTORS CORP.
  3. Connect the MAP sensor/IAT sensor No. 2 connector. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR NO. 2 REMOVAL/INSTALLATION .)
  4. Install the following parts:
    1. Air box complete (See AIR BOX COMPLETE REMOVAL/INSTALLATION .)
    2. Cowl grille (See COWL GRILLE REMOVAL/INSTALLATION .)
    3. Wiper arm and blade (See WIPER ARM AND BLADE REMOVAL/INSTALLATION .)
    4. Front crossmember under cover (See FRONT CROSSMEMBER UNDER COVER REMOVAL/INSTALLATION .)
    5. Front splash shield No. 1 (See FRONT SPLASH SHIELD No. 1 REMOVAL/INSTALLATION .)
    6. Front wheel and tire (See GENERAL PROCEDURES (SUSPENSION) .)
    7. Catch tank (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION .)
    8. Purge solenoid valve (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION .)
    9. Seal cover (See SEAL COVER REMOVAL/INSTALLATION .)
scientia non olet · About LEMON Manuals