LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-9 Signature >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Intake-Air System And Turbocharger) >> Intake-Air System Removal/Installation >> Intake Manifold Removal Note

Intake Manifold Removal Note

WARNING: This page is about a different car, the 2017 Mazda CX-9. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT .)
  2. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION .)
  3. Remove the EGR cooler. (See EGR COOLER REMOVAL/INSTALLATION .)
  4. Remove the EGR pipe. (See EGR PIPE REMOVAL/INSTALLATION .)
  5. Remove the MAP sensor/IAT sensor No. 2. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR NO. 2 REMOVAL/INSTALLATION .)
  6. Disconnect the water hose from the water outlet component.
  7. Disconnect the high fuel pressure sensor connector. (See FUEL INJECTOR REMOVAL/INSTALLATION .)
  8. Disconnect the wiring harness clips from the intake manifold.
  9. Remove the intake manifold.
  10. Remove the bracket from the intake manifold.
Fig 1: Intake Manifold Bracket And Bolts
G11436443Courtesy of MAZDA
scientia non olet · About LEMON Manuals