Using the M-MDS

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Connect the M-MDS to the DLC-2.
After vehicle identification, select the following from the M-MDS initialization screen.
1. "Data logger"
2. "Module"
3. "HUD"
Using the simulation function MAINT_MODE, verify that the display screen and open/close angle for the combiner change each time the light switch is switched between OFF and TNS (parking lights).

Number of times light switch is switched between OFF and TNS (parking lights)	Combiner open/close angle	Display screen
-	Courtesy of MAZDA MOTORS CORP.	Courtesy of MAZDA MOTORS CORP.
1 time	Courtesy of MAZDA MOTORS CORP.	Courtesy of MAZDA MOTORS CORP.
2 times	Courtesy of MAZDA MOTORS CORP.	Courtesy of MAZDA MOTORS CORP.
3 times	Courtesy of MAZDA MOTORS CORP.	Courtesy of MAZDA MOTORS CORP.
4 times	Courtesy of MAZDA MOTORS CORP.	Courtesy of MAZDA MOTORS CORP.
5 times	Courtesy of MAZDA MOTORS CORP.	Courtesy of MAZDA MOTORS CORP.
6 time	Courtesy of MAZDA MOTORS CORP.	Courtesy of MAZDA MOTORS CORP.
7 time	Courtesy of MAZDA MOTORS CORP.	Courtesy of MAZDA MOTORS CORP.
8 times	Courtesy of MAZDA MOTORS CORP.	Courtesy of MAZDA MOTORS CORP.
9 times	Courtesy of MAZDA MOTORS CORP.	Courtesy of MAZDA MOTORS CORP.

If the display screen for the active driving display cannot be changed, refer to the symptom troubleshooting. (See SYMPTOM TROUBLESHOOTING [INSTRUMENT CLUSTER] .)