Front Turn Light Bulb Removal/Installation

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Switch the ignition ON (engine off or on).
Fully turn the steering wheel in the opposite direction of the side the front turn light bulb is being removed.
Switch the ignition off.
Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
Partially peel back the front mudguard. (See MUDGUARD REMOVAL/INSTALLATION .)
Turn the socket counterclockwise and remove it in the direction of arrow (1) shown in the figure.

Fig 1: Locating Front Turn Light Socket
Courtesy of MAZDA MOTORS CORP.
CAUTION:
- If there is oil or dirt on the surface of the light bulb, excessive heat will build up and the life of the light bulb will be shortened. If the light bulb glass area is touched, wipe off any dirt using a soft cloth dampened with detergent diluted in water (approx. 5%).
Remove the front turn light bulb.

Fig 2: Removing Front Turn Light Bulb From Socket
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.