Thrust washer Assembly Note
WARNING: This page is about a different variant/trim than selected.
- Assemble the side gears, thrust washers and pinion gears to the gear case, then assemble the knock pin.
- After assembling the knock pin, make a crimp so that the pin will not come out of the gear case.
- Set a dial gauge to the pinion gear as indicated in the figure.
- Secure one of the side gears.
- Move the pinion gear and measure the backlash at the end of the pinion gear.
- If the backlash exceeds the standard, use the thrust washers to adjust.
Rear differential backlash of pinion gear and side gear
0.1 mm {0.004 in} or less
Thrust washer thickness
| Identification mark | Thickness |
| 9 | 0.90 mm {0.035 in} |
| 95 | 0.95 mm {0.037 in} |
| 0 | 1.00 mm {0.0394 in} |
| 05 | 1.05 mm {0.0413 in} |
| 1 | 1.10 mm {0.0433 in} |