Shift-Lock Solenoid Specification
TEST CONDITION AND VOLTAGE SPECIFICATION
| Terminal | Connected to | Test condition | Voltage (V) |
|---|---|---|---|
| A | IG1 relay | Ignition switched ON (engine on) | B+ |
| Except above | Below 1.0 | ||
| D | Start stop unit | Under any condition | Below 1.0 |
- If the voltage is not as indicated in the table, repair or replace the related wiring harness.
- If the voltage can be verified as indicated in the table, replace the selector lever component. (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION .)