LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Signature >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Active Air Shutter System) >> Active Air Shutter Removal/Installation

Active Air Shutter Removal/Installation

WARNING: This page is about a different car, the 2017 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • If the active air shutter is disassembled and re-assembled, it may not operate normally. Do not disassemble the active air shutter because it is not designed to be disassembled.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Seal board upper (See SEAL BOARD UPPER REMOVAL/INSTALLATION .)
    2. Front bumper (See FRONT BUMPER REMOVAL/INSTALLATION .)
    3. Bumper stiffener lower (See BUMPER STIFFENER LOWER REMOVAL/INSTALLATION .)
  3. Disconnect the connector.
    Fig 1: Locating Active Air Shutter Connector
    G11425831Courtesy of MAZDA MOTORS CORP.
  4. Remove the bolts.
    Fig 2: Removing Active Air Shutter Bolts
    G11425832Courtesy of MAZDA MOTORS CORP.
  5. Remove the tabs.
    Fig 3: Locating Active Air Shutter Tabs
    G11425833Courtesy of MAZDA MOTORS CORP.
  6. Remove the active air shutter.
  7. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals