LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-5 Signature >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Doors And Liftgate) >> Power Liftgate (PLG) Control Module Removal/Installation

Power Liftgate (PLG) Control Module Removal/Installation

WARNING: This page is about a different car, the 2017 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION .)
    2. Bass-box (With Bose ®) (See BASS-BOX REMOVAL/INSTALLATION .)
    3. Sub-trunk (See SUB-TRUNK REMOVAL/INSTALLATION .)
    4. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
    5. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    6. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
  3. Disconnect the connectors.
    Fig 1: Disconnecting Power Liftgate (PLG) Control Module Connectors
    G11425960Courtesy of MAZDA MOTORS CORP.
  4. Remove the bolts.
    Fig 2: Power Liftgate (PLG) Control Module Bolts With Torque Specifications
    G11425961Courtesy of MAZDA MOTORS CORP.
  5. Remove the power liftgate (PLG) control module.
  6. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals