LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> CX-30 Turbo Premium Plus >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security And Locks >> Front Outer Handle Removal/Installation >> Passenger's Side >> Notes

Passenger's Side: Notes

  1. Fully close the front door glass.
  2. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION (US) .)
  3. Remove the following parts:
    1. Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION .)
    2. Power window subswitch (See POWER WINDOW SUBSWITCH REMOVAL/INSTALLATION .)
    3. Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION (US) .)
    4. Front inner handle (See INNER HANDLE REMOVAL/INSTALLATION .)
  4. Disconnect the connector.
    G13560305
    CAUTION:
    • When removing the service hole cover, insert the remover tool so as not to damage the seal rubber.
  5. Detach the service hole cover tabs from the body using a remover tool.
    G13560306
  6. Remove the clips A, B and C.
    G13560307
  7. Remove the grommet.
  8. Pull the door lock knob cable and the inner handle cable from the service hole cover.
  9. Remove the service hole cover. (See SERVICE HOLE COVER INSTALLATION NOTE .)
  10. Disconnect the keyless antenna connector. (with advanced keyless entry system)
    G13560308
  11. While pulling the front outer handle bracket pin in the direction of arrow (1) shown in the figure, pull the front outer handle in the direction of arrow (2) and detach the front outer handle bracket pin from the front outer handle.
    G13560309
  12. Remove the front outer handle in the direction of the arrow shown in the figure. (See FRONT OUTER HANDLE INSTALLATION NOTE .)
    G13560310
  13. Remove the service hole cover.
    G13560311
  14. Loosen the screw.
    G13560312
  15. While moving the lever in the direction of arrow (1) shown in the figure, press the retainer in the direction of arrow (2) using a tape-wrapped screwdriver, and then secure the lever.
    G13560313
  16. Remove the cap. (See CAP INSTALLATION NOTE .)
    G13179018
  17. While pressing the tabs of the clip in the direction of arrow (1) shown in the figure, press it in the direction of arrow (2) to detach the connector tabs from the front outer handle bracket. (with advanced keyless entry system)
    G13560315
  18. Loosen the screw securing the front outer handle bracket.
    G13560316
    NOTE:
    • The screw cannot be removed because the front outer handle bracket has a stopper which prevents the screw from falling.
  19. Pull the front outer handle bracket in the direction of arrow shown in the figure and detach the front outer handle bracket hook from the body.
    G13560317
  20. Lift the front outer handle bracket in the direction of the arrow shown in the figure and pull out the rod from the rod holder. (See FRONT OUTER HANDLE BRACKET INSTALLATION NOTE .)
    G13560318
  21. Remove the front outer handle bracket.
  22. Remove the handle sheet from the body.
    G13560319
  23. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals