Control Cable Ends (Transaxle Side) Installation Note

WARNING: This page is about a different car, the 2018 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Verify that the shift control module is in the neutral position.
CAUTION:
- Pull the lock pin within the range shown in the figure below. If the lock pin is pulled excessively, it could deform and no longer function.
Fig 1: Checking Lock Pin With Range
Courtesy of MAZDA MOTORS CORP.
Install the lock pin to the groove of the control cable ends.

Fig 2: Control Cable End To MTX
Courtesy of MAZDA MOTORS CORP.
Connect the control cable ends to the manual transaxle.
Make sure that the shift lever can be shifted smoothly.