LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> 6 Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Security And Locks) >> Hood Release Cable Removal/Installation

Hood Release Cable Removal/Installation

WARNING: This page is about a different car, the 2018 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Set plate (See SET PLATE REMOVAL/INSTALLATION .)
    2. Fresh-air duct installation bolt (See INTAKE AIR GUIDE REMOVAL/INSTALLATION .)
    3. Front bumper (See FRONT BUMPER REMOVAL/INSTALLATION .)
    4. Front combination light (See FRONT COMBINATION LIGHT REMOVAL/INSTALLATION .)
    5. Horn (See HORN REMOVAL/INSTALLATION .)
    6. Shroud upper member (See SHROUD UPPER MEMBER REMOVAL/INSTALLATION .)
    7. Front mudguard (Driver's side) (See MUDGUARD REMOVAL/INSTALLATION .)
    8. Hood latch protector (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .)
    9. Hood release lever (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .)
  3. Disconnect the hood release cable from the hood latch.
  4. Remove the hood release cable from clip.
    Fig 1: Hood Release Cable From Clip
    G12236236Courtesy of MAZDA MOTORS CORP.
  5. Remove the grommet.
  6. Remove the hood release cable.
  7. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals