LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> 6 Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Drive Selection System (VIN M)) >> Drive Selection Switch Removal/Installation

Drive Selection Switch Removal/Installation

WARNING: This page is about a different car, the 2018 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the selector lever knob. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
  3. Remove the shift panel. (See SHIFT PANEL REMOVAL/INSTALLATION .)
  4. Turn over the removed shift panel and remove the boots from the boots securing parts shown in the figure below.
    Fig 1: Removing Boots From Boots Securing Parts
    G12231969Courtesy of MAZDA MOTORS CORP.
  5. Remove in the order indicated in the table.
  6. Install in the reverse order of removal.
    Fig 2: Drive Selection Switch Components Location
    G12231973Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals