LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> 6 Signature >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Interior Trim) >> Shift Panel Removal/Installation >> ATX

Shift Panel Removal/Installation: ATX

WARNING: This page is about a different car, the 2018 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the selector lever knob. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)
  3. To prevent scratches or damage, apply protective tape to the position shown in the figure below.
    Fig 1: Applying Protective Tape To Shift Panel (ATX)
    G12236497Courtesy of MAZDA MOTORS CORP.
  4. Insert a tape-wrapped flathead screwdriver into the position shown in the figure below, move it in the direction of the arrow, and remove the clips.
    Fig 2: Inserting Tape-Wrapped Flathead Screwdriver Into Shift Panel
    G12236498Courtesy of MAZDA MOTORS CORP.
  5. Hold the shaded areas of the boot shown in the figure below, pull it in the direction of the arrow, and detach clips.
    Fig 3: Boot
    G12236499Courtesy of MAZDA MOTORS CORP.
  6. Remove the shift panel in the direction of the arrow shown in the figure below, while detaching guides.
    Fig 4: Shift Panel
    G12236500Courtesy of MAZDA MOTORS CORP.
  7. Disconnect the commander switch connector.
  8. Disconnect the electric parking brake switch connector.
  9. Disconnect the indicator connector.
  10. While pressing the tab in the directions of arrows (1) shown in the figure below, press it up in the direction of arrow (2) and detach the tabs from the shift panel.
    Fig 5: Detaching Tabs From Shift Panel
    G12236501Courtesy of MAZDA MOTORS CORP.
  11. Install in the reverse order of removal.
    NOTE:
scientia non olet · About LEMON Manuals