LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2021 >> 6 Signature >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Extractor Chamber Removal/Installation

Extractor Chamber Removal/Installation

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Rear splash shield (See SPLASH SHIELD REMOVAL/INSTALLATION .)
    2. Rear combination light (See REAR COMBINATION LIGHT REMOVAL/INSTALLATION .)
    3. Rear bumper (See REAR BUMPER REMOVAL/INSTALLATION .)
    4. Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION .)
    5. Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION .)
    6. Trunk side pocket (See TRUNK SIDE POCKET REMOVAL/INSTALLATION .)
    7. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
    8. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
  3. While pressing the extractor chamber clips in the direction of arrows (1) shown in the figure, move the extractor chamber in the direction of arrow (2) and detach the extractor chamber from the body.
    G12234805Courtesy of MAZDA MOTORS CORP.
  4. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals