Selection of Procedure for 360° View Monitor System Aiming
NOTE:
- For the front camera aiming, side camera aiming, and rear mount camera aiming, 1 set(1 set/2 targets) of the SST (49 JP04 001) are required.
- For the 360° view monitor system aiming (batch aiming), 4 sets(1 set/2 targets) of the SST (49 JP04 001) are required. If 4 sets of the SST (49 JP04 001) is unavailable, perform the aiming for the 4 cameras individually.
- When any of the following operations is performed, it is necessary to verify if the front camera aiming, side camera aiming, and rear mount camera aiming needs to be performed.
- Servicing requiring verification of necessity to perform front camera aiming
- Front camera removal/installation
- Front bumper removal/installation
- Servicing requiring verification of necessity to perform side camera aiming
- Side camera removal/installation
- Power outer mirror removal/installation
- Outer mirror garnish removal/installation
- Side turn light removal/installation
- Front door removal/installation
- Servicing requiring verification of necessity to perform rear mount camera aiming
- Rear mount camera removal/installation
- Trunk lid removal/installation or adjustment
STEP AND INSPECTION PROCEDURE
| Step | Procedure | Action after procedure | |
|---|---|---|---|
| 1 | Was the 360° view monitor control module replaced? | Yes | Go to step 4. |
| No | Go to the next step. | ||
| 2 | To determine if aiming is necessary or not, perform the 360° view monitor system screen display verification procedure. (See 360° View Monitor System Screen Display Verification Procedure ) Is it necessary to perform aiming? |
Yes | Go to the next step. |
| No | Procedure is completed. | ||
| 3 | Which of the cameras requires aiming? | Front camera | Perform the front camera aiming and go to step 5. (See FRONT CAMERA AIMING PROCEDURE ) |
| Side camera | Perform the side camera aiming and go to step 5. (See SIDE CAMERA AIMING PROCEDURE ) |
||
| Rear mount camera | Perform the rear mount camera aiming and go to step 5. (See REAR MOUNT CAMERA AIMING PROCEDURE ) |
||
| 4 | For the 360° view monitor system aiming (batch aiming), 4 sets of the SST (49 JP04 001) are required. Are 4 sets of the SST (49 JP04 001) available? |
Yes | Perform the 360° view monitor system aiming (batch aiming) procedure and go to step 5. (See 360° View Monitor System Aiming (Batch Aiming) Procedure ) |
| No | Individually perform aiming for the camera requiring aiming, then go to Step 5. (See FRONT CAMERA AIMING PROCEDURE ) (See SIDE CAMERA AIMING PROCEDURE ) (See REAR MOUNT CAMERA AIMING PROCEDURE ) |
||
| 5 | Perform the 360° view monitor system screen display verification procedure. (See 360° View Monitor System Screen Display Verification Procedure ) Is 360° view monitor system aiming procedure needed? |
Yes | Repeat Step 4. |
| No | Procedure is completed. | ||