Coupling Component Calibration Data Writing

CAUTION:

• If the characteristic value of a new coupling component is not input to the PCM or the characteristic value is input incorrectly after replacing the coupling component, it could result in the following conditions.
  • The system does not operate normally.
  • A problem with durability of the coupling component occurs.
• After replacing the coupling component, read out the characteristic value of a new coupling component and write it to the PCM.
• Read out the characteristic value of the coupling component from the label or mark shown in the figure.

NOTE:

• The Writing the characteristic value of coupling can be performed using the M-MDS.

Courtesy of MAZDA MOTORS CORP.

1. Connect the M-MDS to the DLC-2.
2. Perform the Writing the characteristic value of Coupling.
3. Perform the Reading the characteristic value of Coupling.