Front Brake Mounting Support Removal/Installation (Us): Notes
Replacement Part
| Dust boot | Bush | Spring |
| Quantity: 2 | Quantity: 2 | Quantity: 2 |
| Location of use: Front brake mounting support | Location of use: Slide pin | Location of use: Disc pad component |
Oil and Chemical Type
| Brake grease (Brown-gray) | Brake grease (White) | Rubber grease (Orange-red) |
| Type: PLASTILUBE | Type: KLUBER | Type: NIGLUBE |
- Remove the wheel and tire. (See WHEEL AND TIRE REMOVAL/INSTALLATION .)
- Remove in the order indicated in the table.
- Install in the reverse order of removal.
- Depress the brake pedal a few times, rotate the wheel by hand, and verify that the brake does not drag.
PART DESCRIPTION
| 1 | Bolt |
| 2 | Front brake caliper (See FRONT BRAKE CALIPER REMOVAL NOTE .) (See FRONT BRAKE CALIPER INSTALLATION NOTE .) |
| 3 | Slide pin |
| 4 | Bushing |
| 5 | Dust boot |
| 6 | Spring (if equipped) |
| 7 | Disc pad component |
| 8 | Guide plate (See GUIDE PLATE INSTALLATION NOTE .) |
| 9 | Bolt |
| 10 | Front brake mounting support |