Tie-Rod End Replacement: Installation

Place alignment marks on the new tie-rod end in the same positions as the removed tie-rod end.

Courtesy of MACK TRUCKS, INC.
Align the marks that were made before removing the tie-rod end, and assemble the tie-rod end to the tie rod.

Fig 1: Tie-Rod End, Alignment Mark And Nut With Torque Specification
Courtesy of MACK TRUCKS, INC.
Verify that dimension A shown in the figure is within the standard.

Courtesy of MACK TRUCKS, INC.

Standard

5.8-18.8 mm {0.23-0.74 in}
- If not within the standard, make adjustments so that dimension A is within the standard.
Install the tie-rod end to the steering knuckle.

Fig 2: Tie-Rod End, Steering Knuckle Locknut With Torque Specification
Courtesy of MACK TRUCKS, INC.
Install a new snap pin.

Courtesy of MACK TRUCKS, INC.
Install the wheel and tire. (See WHEEL AND TIRE REMOVAL/INSTALLATION .)
Verify that A and B shown in the figure are parallel while the vehicle is on the ground.

Courtesy of MACK TRUCKS, INC.
CAUTION:
- Install the tie-rod end to the correct position. Otherwise, it could cause cracks on the tie-rod end boot.
- If the installation position is not correct, perform the adjustment using the following procedure.
1. Adjust the tie-rod end by rotating it so that it is at the correct position.
Courtesy of MACK TRUCKS, INC.
After installation, inspect the front wheel alignment. (See FRONT WHEEL ALIGNMENT (US) .)