Function Inspection Using M-MDS

DIAGNOSTIC PROCEDURE - FUNCTION INSPECTION USING M-MDS

Step	Inspection	Results	Action
1	PURPOSE: RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION Record the freeze frame data/snapshot data. NOTE: Recording can be facilitated using the screen capture function of the PC.	-	Go to the next step.
2	PURPOSE: VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY Verify related Service Bulletins, on-line repair information, or Service Information availability. Is any related Information available?	Yes	Perform repair or diagnosis according to the available information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	PURPOSE: VERIFY ENGINE OIL TEMPERATURE SENSOR INPUT SIGNAL Start the engine and idle it. Access the ENG_OIL_TEMP PID using the M-MDS. (See PID/DATA MONITOR INSPECTION .) Is the PID value within specification?	Yes	Go to the next step.
3		No	Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 2.
4	PURPOSE: VERIFY CONNECTOR CONNECTIONS Start the engine. Access the ENG_OIL_TEMP PID using the M-MDS. (See PID/DATA MONITOR INSPECTION .) Does the PID value fluctuate when the following connectors are shaken? Engine oil temperature sensor/engine oil pressure sensor PCM	Yes	Repair or replace the applicable wiring harness or connector parts. Go to Troubleshooting Diagnostic Procedure to perform the repair completion verification.
4		No	Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1.