Error code 01/05

ERROR CODE (01/05) INSPECTION AND ACTION DESCRIPTION

Step	Inspection	Action
1	VERIFY THE INPUT VALUE Verify the value indicated in Step 23 for aiming with the input value. Is the value input correctly?	Yes	Go to the next step.
1		No	Input the value indicated in Step 23 for aiming, then go to the next step.
2	VERIFY TARGET POSITION Verify the following. Are the vehicle and target setting screen set on level ground? Is the target set to the position indicated in the aiming procedure? Are the board and the target set line parallel and is the height at the center of the target correct? Was the target made as instructed in the procedure? Is there any dirt, cracks, damage, or wrinkling on the target and board? Is there a malfunction?	Yes	Repair the target for malfunction and go to the next step.
2		No	Go to the next step.
3	PERFORM FSC AIMING Perform the FSC aiming. Is the FSC aiming procedure completed correctly?	Yes	FSC aiming procedure is completed.
3		No	DTC 01/05 is displayed Error code other than error code 01/05 is displayed Go to the next step. Go to the procedure for the displayed error code.
4	PERFORM THE FSC AIMING PROCEDURE USING THE ACTUALLY MEASURED VALUE Measure the distance from the target to the front wheel center. Perform the FSC aiming procedure using the actually measured value. Is the FSC aiming procedure completed correctly?	Yes	FSC aiming procedure is completed.
4		No	Go to the next step.
5	VERIFY DTC Perform the DTC inspection for the FSC. (See DTC INSPECTION .) Is a DTC displayed?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [FORWARD SENSING CAMERA (FSC) (US)] .) (See DTC TABLE [VEHICLE CONTROL MODULE (US)] .)
5		No	PERFORM FSC AIMING AGAIN Switch the ignition OFF. Close all doors and wait for 6 min or more. Perform the FSC aiming procedure again and if it is not completed successfully, replace the FSC. (See FORWARD SENSING CAMERA (FSC) REMOVAL/INSTALLATION .)