LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2020 >> CX-9 Sport, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Symptom Troubleshooting - Automatic Transaxle >> Starter Does Not Work >> Diagnostic Procedure

Diagnostic Procedure

STARTER DOES NOT WORK (GW6A-EL, GW6AX-EL) DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 INSPECT WIRING HARNESS BETWEEN TCM AND PCM
  • Switch the ignition off.
  • Disconnect the PCM connector and TCM connector.
  • Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between TCM terminal J and PCM terminal 2BD.
  • Is there any malfunction?
 Yes Repair or replace any malfunctioning parts according to the inspection result.
No Go to the next step.
2 INSPECT WIRING HARNESS BETWEEN TCM AND START STOP UNIT
  • Disconnect the start stop unit connector.
  • Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between TCM terminal J and start stop unit terminal 1F.
  • Is there any malfunction?
 Yes Repair or replace any malfunctioning parts according to the inspection result.
No Go to the next step.
3 INSPECT WIRING HARNESS BETWEEN TCM AND LF CONTROL UNIT
  • Disconnect the LF control unit connector.
  • Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between start stop unit terminal 2H and LF control unit terminal G.
  • Is there any malfunction?
 Yes Repair or replace any malfunctioning parts according to the inspection result.
No Go to the next step.
4 INSPECT IMMOBILIZER SYSTEM AND ENGINE CONTROL SYSTEM FOR MALFUNCTION
 Yes Repair or replace any malfunctioning parts according to the inspection result.
No Symptom troubleshooting is completed.
scientia non olet · About LEMON Manuals