Camber Adjustment

WARNING: This page is about a different car, the 2020 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

Loosen the installation nut of the lower link adjusting cam bolt.

Courtesy of MAZDA MOTORS CORP.

Rotate the adjusting cam bolt in either direction to adjust the camber.

Specification

Vehicle height⁽¹⁾

Camber

350-358 {13.8-14.0}

-1°23'±1°

359-367 {14.2-14.4}

-1°09'±1°

368-376 {14.5-14.8}

-0°57'±1°

377-385 {14.9-15.1}

-0°46'±1°

386-394 {15.2-15.5}

-0°37'±1°

⁽¹⁾	Vehicle height: From the end of the rear fender to the center of the wheel (mm {IN})

	Left wheel	Right wheel
Positive direction	Clockwise	Counterclockwise
Negative direction	Counterclockwise	Clockwise

NOTE:

Refer to the following figure to adjust the angle of the adjusting cam bolts in single increments.

Lower link adjusting cam bolt adjustment table

Scale	Link movement (mm {IN})	Camber change amount (angle)
1	1.8 mm {0.071 in}	-0°35'
2	3.5 mm {0.14 in}	-1°08'
3	4.9 mm {0.19 in}	-1°36'
4	6.1 mm {0.24 in}	-1°58'
5	6.8 mm {0.27 in}	-2°11'
6	7.0 mm {0.28 in}	-2°16'

Tighten the nut.
Tightening torque

85-103 N.m {8.7-10 kgf.m, 63-75 ft.lbf}