Using a speedometer tester
CAUTION:
- When only the front or the rear wheels are driven using a speedometer tester, the DSC HU/CM may determine that the vehicle speed signal is in error and the engine cannot be stopped by the normal operation. If the engine cannot be stopped, perform an emergency engine stop operation. (See SERVICE CAUTIONS .)
- Adjust the tire pressure to the specification. (See WHEEL AND TIRE SPECIFICATION .)
- Using a speedometer tester, verify that the values are as indicated in the table.
Type A
Speedometer indication (km/h) Speedometer tester indication (km/h) 20 20 40 40 60 60 80 80 100 100 120 120 140 140 160 160 180 180 200 200 220 220 240 240 10 10 20 20 30 30 40 40 50 50 60 60 70 70 80 80 90 90 100 100 110 110 120 120 130 130 140 140 150 150 Type B
Speedometer indication (km/h) Speedometer tester indication (km/h) 20 17.57-22.43 40 37.67-42.33 60 57.57-62.43 80 77.47-82.53 100 97.12-102.88 120 116.66-123.34 140 136.26-143.74 160 156.26-163.74 180 176.26-183.74 200 196.13-203.87 220 215.82-224.18 240 235.82-244.18 10 8.50-11.50 20 18.55-21.45 30 28.50-31.50 40 38.45-41.55 50 48.36-51.64 60 58.16-61.84 70 67.92-72.08 80 77.74-82.26 90 87.68-92.32 100 97.68-102.32 110 107.68-112.32 120 117.58-122.42 130 127.40-132.60 140 137.40-142.60 150 147.40-243.60 Type C
Speedometer indication (km/h) Speedometer tester indication (km/h) 20 18.00-22.00 40 38.00-42.00 60 57.75-62.25 80 77.50-82.50 100 97.25-102.75 120 117.00-123.00 140 136.75-143.25 160 156.50-163.50 180 176.50-183.50 200 196.25-203.75 220 216.00-224.00 240 236.00-244.00 10 8.75-11.25 20 18.75-21.25 30 28.75-31.25 40 38.50-41.50 50 48.50-51.50 60 58.25-61.75 70 67.00-71.00 80 77.75-82.25 90 87.75-92.25 100 97.75-102.25 110 107.75-112.25 120 117.75-122.25 130 127.50-132.50 140 137.50-142.50 150 147.50-152.50 - If not as indicated in the table, perform the DTC inspection for the PCM and DSC HU/CM, and inspect the related wiring harnesses.
(See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION))]
.)
(See DTC INSPECTION [DYNAMIC STABILITY CONTROL (DSC)]
.)
- If the PCM, DSC HU/CM, and related wiring harnesses are normal, replace the instrument cluster. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION )
- If not as indicated in the table, perform the DTC inspection for the PCM and DSC HU/CM, and inspect the related wiring harnesses.
(See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION))]
.)
(See DTC INSPECTION [DYNAMIC STABILITY CONTROL (DSC)]
.)